Really pleased with my Benchy.
just created my next print and went to change filaments (from Benchy Red to white)
It wouldn't move so I heated Hotend 1 to 200 as per benchy released the cam on the feed and pulled it nearly came out but then got stuck.
I also noted that there are now striations on the red filament I pulled back.
Could someone tell me what the correct process is for changing filaments?
My personal process for changing filament is to heat up the hotend, pull the filament a few CM then push back in slightly and then quickly pull back out which causes the end to stretch into a point rather than leaving a blob.
If you do get a blob and it gets stuck at the coupling then simply remove the ptfe tubing from the coupling, snip away the blob and pull the filament out as normal and then re-attach the tubing.