Return to Forum
Return To Mainsite
To see this working, head to your live site.
  • Categories
  • All Posts
  • My Posts
Ryan Andrews
Dec 11, 2019

Factory Reset?

in General Discussion

Is it possible to factory reset the software?


Everything was fine yesterday, but then this morning when I turned on my printer, it is showing Hotend 1 at 154 degrees, Hotend 2 at 21 degrees, and the Heated Bed at -15 Degrees, with the Fan Speed at 0.


That is obviously incorrect. I checked the wiring to make sure nothing came unplugged.


Any thoughts?


@Makertech have you experienced this before?

2 comments
0
Ryan Andrews
Dec 14, 2019

Further update, I tried swapping the Heated bed connector with one of the hotends and none of the temperature readings changed when I turned it back on. So that means that either the software has a bug (that is persisting through reboots) or some of the ports on the main board have been fried and no longer read the correct temperatures.


PS. I can heat up Hotend 1, and the display will show it increasing from 154 degrees (but it will never go lower than that). I can also heat up Hotend 2, but the display doesn't show the temperature as changing. If I try to heat up the bed, it throws an error about being under the minimum temperature.


PSS. Pronterface shows the same things as the touchscreen.

0
Ryan Andrews
Dec 20, 2019

I bought a replacement for my control board on Amazon and everything seems to be in order now

0
2 comments

Copyright © Makertech 3D Ltd. 2020 - All Rights Reserved. - U.K. Company No. 10715504 - U.K. VAT No. GB 273781181

Return to main site here.