Does anyone have an idea how I can solve my problem: I am working with Proforge 3 Direct Drive Extruder. The printer has recently stopped printing. Two weeks ago the same files were printed correctly, now the extruder is blocked towards the end of the print job. This has been cleaned several times with cleaning filament. The problem occurs with different filaments. The printer settings can be seen in the photos. Could it be that the orbiter drive is defective?
I am very grateful for a helpful idea.
Herman
Seting in separat Post
its heat creep. it was a major problem on the 3, probably on the 3.5 too. i upgraded to a water cooled hotend and the problem went away. you could try ducting the heatsink cooling fan to get coler air from outside the printer.