Thanks, once I got it assembled (I'm still waiting for the upgrade assembly guides) I will install marlin to verify if everything is working correctly and then move over to mainsail and Klipper which I already use on my other printers. This can take some weeks and I have to learn how to properly work with GitHub but if I can help with adding config sections I will do
@Johannes Weis 2 non-essential codes I always add are the temp sensors of the raspberry pi and the mcu (skr2) [temperature_sensor raspberry]
sensor_type: temperature_host
[temperature_sensor MCU]
sensor_type: temperature_mcuIn mainsail and fluiddpi this will automatically add them to the chart.I also always add the idle_timeout section too. [idle_timeout]
timeout: 500
gcode:
{% if printer.pause_resume.is_paused %}
M104 S0
{% else %}
TURN_OFF_HEATERS
M84
{% endif %}By doing this the bed will stay heated and the stepper motors enable when paused. Ideal for M600 macro's.I think to further build on the config it would be good to follow the [include] route and separate the sections that can differ from the bought upgrades. This way somebody just has to comment/uncomment single lines for their setup.
Thanks, once I got it assembled (I'm still waiting for the upgrade assembly guides) I will install marlin to verify if everything is working correctly and then move over to mainsail and Klipper which I already use on my other printers. This can take some weeks and I have to learn how to properly work with GitHub but if I can help with adding config sections I will do