I had a problem with autolevelling where it'd get to the first point, and stop as soon as the sensor triggered. Tried looking into the problem and saw a similar issue on the Marlin github that was fixed by updating to the latest version, so I attempted to update the Marlin firmware from Makertech's github to the latest Marlin branch - https://github.com/callym/Marlin Not actually gotten around to doing any prints with my Axis yet so be a bit cautious if you decide to use this, but it did fix my error with the levelling, and testing the homing, moving axis, heating hotend and bed, all worked fine.

Hi so I've just finished wiring everything and my raspberry pi is giving a low voltage warning in octoprint. I've tried with an external USB plug (even using the same cable!) and it works fine, so I'm guessing it's something off with the included USB adaptor thingy. I've got a 3B+ Pi, if that makes any difference. I've not plugged in the camera or anything yet so that's not drawing any power from the pi (not sure if that'd even affect the voltage) I tried checking the connections in the terminal block and they're all fine, taking them out and putting them back in made no difference.