@Makertech Thank you. This resolved my issue. it looks like the heated bed cable was a little loose. Fixed the issue and i am back up and running.

Update on My Heated Bed. So after i was able to get some ok prints my heated bed no longer heats up. The red LED no longer turns on. The thermistor is still working just not the bed heating.

With this issue I believe I have atleast for now remedied the issue. I used 3M F9473PC tape. I have had multiple successful prints with it and the board no longer bows. I had to buy it on eBay because i Could not find any affordable timely places to buy besides EBay.

I did the same thing and have no issues. Just make sure you watch the camera getting hit as fg stated. It will happen if placed a tad to close.

I had an issue with the print sticking, im using the flex plates and what i have done to fix this issue is adding washable glue stick to the build surface. since its the removable flex plate makes cleaning it off easy since i can remove it. Glue stick works great and has helped a lot in keeping prints down.

No I am using the single extruder right now. In my specific case I believe I figured it out. My printing bed when heated warps. Makertech is replacing it. (My opinion of what is causing this auto level issue) This warping is causing the auto level to fail because the difference in the middle to the corners is too great.

Thank you for the response I have sent the form in to get a replacement

So, I don’t know what was causing my problem but I rebuilt the rollers and that seems to have fixed the problem putting on each side individually and tightening very slowly I don’t hear the rubbing and it moves pretty easily besides the tension of the motor.