Hope all is well with everyone! I am seeking some assistance and happy to pay for a few hours of someone's time. Goal: toggle on enclosure chamber heater pre print to speed up chamber heat up time, then toggle off before printing begins via Gcode produced from the slicer. I am hoping to run a small chamber heater powered by a relay. Obviously I would need to be able to toggle a pin via Gcode before a print start for a set amount of time. After reviewing our boards (skr2) I see there are a few unused pins, but none are thermistors thus I would just have to toggle on the heater via Gcode for a set amount of time after experimentin. I want to be able to get chamber temp up quicker than waiting on the bed heater alone. I am not looking to run excessive chamber temps. I would need guidance on klipper firmware script and verifying the relay and heater selection make general sense. Free Pins: PE8(ps-on) PC15(pwrdet) PB6(Fan1) Any guidance would be appreciated and I am happy to pay for your time. Sincerely, Jeremiah