top of page
Reurn to Forum Home
Forum Comments
Marlin 2.x
In Marlin Firmware
Willy Duffle
Sep 30, 2020
Meant to post this a long time ago but life happens. I couldn't do crap with the teflon tape method so I made a slot in a piece of acrylic and applied wax to it then filled it with silicone then pushed the parking tab into it and let it dry (actually made two of these molds and did both at the same time). Afterwards I removed it from the acrylic mold and now I have silicone pads (that were originally promised) bonded to the tabs and it works great to prevent leaking and lets me actually use the second head to do multi-material printing. Thanks for the youtube link déro. I'm upgrading to a MKS SGEN L v1.0 with Marlin 2.0 and TMC2208s since one of my TMC2100 drivers went bad. Did you have to copy over all the .cpp & .h files from Marlin 1 (excluding the config.h and config.adv.h) before building Marlin 2 or did you get it running with just the minimum that comes with marlin?
0
0
Hotend_Offset_Y
In Marlin Firmware
Willy Duffle
Jun 16, 2019
Thanks! Yes, I did when I was experimenting with the octoprint gcode commands because reflashing takes forever. I think the only thing I haven't copied into the eeprom from the config file is this setting so I will try that tonight.
0
0
Willy Duffle
0
Followers
0
Following
Follow
Following icon
More actions
Profile
Forum Posts
Forum Comments
bottom of page