switch on the printer. Got green led light from the power unit. Got red led to the hotbed circuit board. But, the merlin board will not bootup, and no power to the fan. Any suggestion?
top of page
To see this working, head to your live site.
3 Comments
bottom of page
While you might be enticed to pull this hustle move, you should recollect that that is precisely exact thing you are doing Pulling a con on a clueless individual online dater. Sure you might get the dating profile review service date, however your dating accomplice will not have the option to help being disheartened assuming that you sell yourself as a gazelle and appear as Garfield.
Don't if anyone will find this useful. Just confirmed got a dead power supply. voltage output is only 4V.
What I have done so-far
Repeat Step 8, re-load the firmware. But, only one hotend fan is running. But, not the electronic fan.