1.
Connecting...
start
Printer is now online.
echo:Marlin 2.0.5.3
echo: Last Updated: 2020-03-31 | Author: (none, default config)
echo:Compiled: Aug 14 2020
echo: Free Memory: 3407 PlannerBufferBytes: 1232
echo:EEPROM version mismatch (EEPROM=? Marlin=V76)
echo:Hardcoded Default Settings Loaded
Testing X connection... Error: All LOW
Testing Y connection... Error: All LOW
echo:SD init fail
2.
i can´t write a new (invertet x and y) Configuration.h File to the Printer...
3.
It is normal that i hear a klick, klick, klick the hole time the printer is connectet with the usb Cabel?
Where is the fault?
thanks and Greets from Germany
Thomas
Hallo! Wie ghet's?
1.) If you have the TMC2208 upgrade, you have to ensure that you made the change in the firmware to reflect that.
2.) If you have already made that change, then it's related to you not being able to write the firmware file to the printer. Does it give you a specific error when you try to upload the firmware?
No, the clicking noise is not normal. If you have the LCD display make sure that your LCD wires are correct. I had to modify mine by cutting off the little lock tab on one side. https://makertech-3d.dozuki.com/Guide/Stage+01:+Base/50?lang=en#s574