Hi all, I have one of the first kickstarter Proforges and I wanted to switch to Marlin 1.1.9 and after sorting out the config I have the issue that the printer stops repeatedly during printing via Octoprint . It seems to me that the printer is waiting for commands from the octopi, the terminal window showed the following error message: Communication timeout while printing, trying to trigger response from printer. Configure long running commands or increase communication timeout if that happens regularly on specific commands or long moves. Recv: Error:checksum mismatch, Last Line: 165 This never occured with the stock marlin version.
Has anyone had issues getting the
y-axis offset calibrated on the dual head extruder? My single material prints are beautiful but the second nozzle is about +1mm off in the y and I have tried modding the offset in the firmware by 2mm and it is still the same, like it had little to no effect. Is there anything else I have to adjust to make it take? I already adjusted my z-offset with great success.