I've had trouble with the Mic6 bed warping during heating / cooling.
My OEM bed was almost 2mm concave. I milled it down flat, now I get almost 1mm convex during heat/cool cylces due to the bed being rigidly mounted.
I created a kinemtic bed upgrade.
That moved the bed to the exact center of the frame. It comes offset towards the front of the printer from Makertech.
Anyone know how to change the XY parameters of the printer?
To clarify, I'm not looking for X/Y offset.
Rather, I'm attempting to reconfigure the bed position so that the bed is dead center of the frame.
I'm not sure if this is done in the firmware (.bin) file or ?
I have not been able to find any designation in the printer.cfg file.