top of page
Forum Posts
Starbeamrainbowlabs
Aug 29, 2020
In Assembly
I'm on Stage 08 → Steps 19 and 20, and I'm installing the stepper drivers. I have: 3 x white TMC2208 stepper drivers 4 x red A4988 stepper drivers I ordered the following upgrades: Heated bed Flexplate Power pack Dual extrusion Silent printing upgrade (3 x pieces) I'm confused as to where I need to install which stepper drivers. I have 5 holes on the control board (as far as I can tell) in which stepper drivers can go. I have 2 of the white TMC2208 boards in the left-most holes (identically to how the guide suggests). Should I leave the other holes empty? Or should I install some stepper drivers in them? If so, which ones: white or red? Below: A picture of what I have installed already. Note the extra 3 holes to the right of the white TMC2208 boards. I now have 1 x white TMC 2208 + 4 x red A4988 boards left.
0
1
39
Starbeamrainbowlabs
Jan 20, 2020
In General Discussion
Hello, I backed the Axis 3D Kickstarter a few months ago, and while I'm waiting for it to be delivered in ~April-May time (it'll be my 1st 3D printer!) I've been ding some research about filament. I live in the East Riding of Yorkshire, and my council does not collect PLA for recycling / composting. What's the best way to responsibly dispose of it - e.g. failed prints etc? If there's no good way to do so, are there any alternative filaments that are easier to responsibly dispose of at the end of their useful life?
0
3
38
Starbeamrainbowlabs
More actions
bottom of page