You can't use the printer anyway at the moment as the firmware isn't available either..... You can look at the DSH v2 instructions for non-proforge printers if you can't wait
@Frederik Weis They've been very good at keeping their promises so far. I'm sure it will be released soon™
Honestly...If they had just been open about the delays when they happened and added some extra buffer time I think a lot of people would be a lot happier to wait. Repeatedly breaking your promises leaves a bad taste....
Their GitHub is also still completely empty so far....
Please release these instructions makertech, we really need you to prioritize pushing out all instructions and firmware so that we can assemble and use the printer.
You can't use the printer anyway at the moment as the firmware isn't available either..... You can look at the DSH v2 instructions for non-proforge printers if you can't wait
Really.... I didn't realize that. So the printer doesn't have the firmware to go on the main board for either the single or DSH?
@Gregory Zilber Yes! In the Kickstarter comments the MakerTech-Team said, that it'll be released soon, whatever that means :/
I guess they'll release the .bin-File so that you can directly flash the board by copying it on the SD-Card and placing the card inside the board.
Would be awesome if they would release the complete firmware so that you can change settings and review the settings the vendor made.
@Frederik Weis They've been very good at keeping their promises so far. I'm sure it will be released soon™
Honestly...If they had just been open about the delays when they happened and added some extra buffer time I think a lot of people would be a lot happier to wait. Repeatedly breaking your promises leaves a bad taste....
Their GitHub is also still completely empty so far....
Please release these instructions makertech, we really need you to prioritize pushing out all instructions and firmware so that we can assemble and use the printer.